patch cord การใช้

• Tabulator control panels could require dozens of patch cords for some applications.
• In other words, different combinations of patch cord connections produced different sounds.
• The circuits are then interconnected to the final destination using patch cords.
• It was like aluminum boxes, little knobs sticking out, and patch cords.
• Programming the instruments meant placing the patch cords to connect the individual modules.
• No mode conditioning patch cord is required for applications over OM3 or OM4.
• A patch cord is always fitted with connectors at both ends.
• The plugs are frequently used to terminate patch cords for electronic test equipment.
• However, patch cords typically refer only to short cords used with patch panels.
• It was programmed using patch cords that connected nine operational amplifiers and other components.
• Early modular synthesizers were large instruments that used patch cords to route the signal flow.
• It was supplied with additional patch cords incorporating special resistors, capacitors, and diodes for further capabilities.
• No patch cord should be longer than 5m.
• These patch cords are typically used with the and the Cross-Connect topology utilizes GigaBIX cross-connect wire.
• Pearlman eschewed patch cord methodology for interconnecting synthesizer modules, designing instead a system of sliding matrix switches.
• For MMF links the WDM output needs to be coupled through a SMF offset-launch mode-conditioning patch cord.
• Users create sounds by manipulating patch cords to direct the signal through the modules above the keyboard.
• Modular synthesizers used cables ( " patch cords " ) to connect the different sound modules together.
• These became known as " patch cords ", and that term was also used for Moog modular systems.
• For link distances greater than 300 m, the use of a special launch conditioning patch cord may be required.